Has anyone using the P400 controller experienced the ACU CLI utility
reporting the physical disks incorrectly?  Whenever I do a show config
detail from the hpacucli (and hpaducli), it reports the three drives
as all being 0:0 with box 0 bay 0 and is reporting the model

We installed MSIE 8 on a Windows 2003 server that is installed on a DL385
G1.   The Array Configuration Utility now is broken, complaining that other
instances are now running.     Is this a known incompatibility with MSIE 8,
and is there a workaround?

Under Windows 2003, we have a P600 array controller that is connected to an
external MSA50 enclosure loaded with 2.5 SAS drives.    For various reasons
this external enclosure was left turned off, and when we turned it on, we
were not able to recover the logical devices on it.    ...

On my laptom HP dv9230 was replaced at first motherboard. Then i was
find clock all the time going down. After i was repleced the cmos
battery. And nothing change. When i switched off and on laptop nothing
change. Time was same like before switched power off.

Have just gotten this computer and as far as I know the hardware is ok
'cause I can't do anything with it OS wise.  It has vista now and since I'm
pirateing parts off my old computer I would like to install the Windows XP
home SP 2 OS from the old computer on the one I've just ...

Just acquired HP Proliant ML350 G5 & HP Netserver LH3000 U3 hardware
Any suggestion as to where to acquire the various manuals
(setup/install/user) etc ?
Thanks for any help

Sorry to post this in c.s.h.h but I can't find any IBM server or Mylex
specific groups.
I have a Mylex DAC960 SCSI RAID controller PCI card installed in
an IBM xSeries 330. I have an external 4mm DAT drive connected

I got a DesignJet 750c with a Jetdirect J2552A card and just can't get
it to work in my network. I succesfully chnged the mio settings to fit
the ip range of my router (Speedport 503v) like this:
I set the IP of the plotter to 192.168.2.9