I've got a Cisco 3661 that boots over the network. I'd like to have this
local but it only has 16 MB flash, my IOS image is bigger.
Can I use a generic PCMCIA card, will it work?
Regards

I have a 10gb x2 fibre sr connector on an F5 and trying to connect it
to a 1000 base sx SFP connector on a cisco 3560, there is no
connection (no link). Are these incompatable with each other? Im not
sure why there is no connection, I thought the recieve/transmit may be

I'm trying to familarise myself with the WLC GUI, does anyone know how I
can emulate the GUI on my PC without an actual WLC?
Thanks
Peter

hi.. I am a newbie to Networking.. and wish to start learn CISCO
CCNA.. But have no idea about, which device should be used setup lab
at home .. I need to buy a device that would help me in many other
CISCO certifications. I found one

My company has a 12Mbps LES Circuit internet link. We are starting to
provide video conferences over the internet using the 12Mbps link.
What I
would like to do is by using rate limiting is  guarantee say 3Mbps

It's been ages since I did any ISDN configuration work.
I have to configure dial in for approx 25 sites to a central router with
a PRI card. I am happy with all the standard router config, it's just
the PRI config that's a little unclear in my head. In the past I would

Please give me the required guideline for configuring up to 32
permanent virtual circuits (PVC) per HWIC-4SHDSL if it is feasible.
I am using a CISCO3845 router with two of HWIC-4SHDSL and the IOS of
S384AESK9-12415T.

I'm a kind of a Cisco newbie and like to see some questions answered I do
not understand...
Situation;
Using an Linksys router controlling my internetconnection (static IP).

For cisco switch, it has access and trunk port and other venders
have access,trunk and hybrid port. How does cisco support
hybrid port function?
TIA,

I'm having a brain fade, for the life of me I can't see any difference
between the two. Except that you can turn on default-information
originate before entering a static route on a router. Redistribute
static should be used after the command entering a static route??

CME/CUE newbie warning...
I'm working in a test environment.  I have a Cisco 2691 running C2691-
ADVIPSERVICESK9-M, Version 12.4(21) and CME 3.4, with an AIM module
running CUE 3.2.2.  I have two phones registered, a 7940 and a 7960.

I have a Cisco 3560. I must plug a XLAN link on a port. This port must
be forced at 100Mb full duplex to enable the connexion.
When i forced the port, the interface become down...
Why?

I recently moved to a area with faster internet access then I
previously had. I am able to connect directly to the cable modem
(comcast) and download starting at 2.0mb/s and it trickles down to
about 1.4mb/s from my dedicated host. When I utilize my Cisco 3725

I am trying to figure out how to set up my 1812w to run two wan
connections (dsl) and to portion them out on the single router.
I have read that they have "load balancing" is this so.  How can this
be set up.  I am just  starting to get my hands "dirty" with cisco, so

are there any (free) third-party vpn clients that work with cisco
hardware?
eg: I have a cisco 2600 router that can do the vpn server thing, but the
cisco vpn client is only available to (paying) registered users. The ms