I use ASA WebVPN with portforwarding feature to ensure terminal services
access to some internal servers.
Everything worked fine untill few days ago...now I can connect and log-me in
but when i launch the microsoft remote desktop it does not work and in the

I have a pix 515E. It's possible to have two internet links (A and B)
(two ISPs differents) and to have two internal networks
(C and D), so that network C leaves by A and D leaves by B.
that command i need???

I copied the MPLS VPN configuration (with slight modifications) from the
following document but can't ping any remote addresses in the VRF.
http://www.cisco.com/en/U...ple09186a00800a6c11.shtml
The routing tables/path on all of the PE routers are correct and there

Hi experts.
We have a 2811 CME system running with two routed subnets. One is for
management (192.168.1..../24), the other (192.168.2.../24) for the offices.
I have put an ACL on the office subnet, everything's fine here. But... how

I have a customer who would like to have the destination port changed
from 162 to 90000 at the firewall. 162 is the destination port as seen
by the agent on the PC. ie
123.123.123.123.161 sends to 321.321.321.321 162.

i've a CCME 4.0 with about 30 phones and phone lines with DID
i'd like to configure the system if an external call come directly to an
internal extension, if no answered, after some seconds the call will be
transfered to the operator phone.

I've got AP's that previously had no problem communicating but as of
the last few days I haven't been able to login to them via SSH
(they'll time out) nor ping them... they show up in a cdp neighbor on
the 3750 PoE switch they're plugged into, and a show cdp entry will

I have two Gig ports configured (trunks) with allowed vlans 100,101
and 200.
Each of these belong to port-channel 1.
And I have the same on the other switch.

Hope this is not to verbose.
-- What I am trying to do:
I am trying to configure a Cisco 2948G-L3 and a Cisco 3548 for vlan
trunking.  I am

I am being tasked to map a network.  In the past I have used nmap to
find the systems on the local LAN and remote LANs (same enterprise).
This time I want to create a visual map of the LAN.  With cheops, I
reasonably good results but cannot be documented for managers with

Is there an IOS command that will reset a configured switch/router
interface back to it's default, out-of-box setting?
Thanks

I config. ospf between two routers. (point to point).
I use "broadcast" parameter. It does not work, then
back to "point to point" it works.
I curious that how router know it connect to p2p or broadcast.

I am trying to connect two remote sites using dedicated point to point
T1. The router at each site is Cisco 2620.
Currently, there is only one WIC card in each of the 2620 router. My
question is about the network subnet between the two routers.

cisco catalyst 6009 (2 BGP peers serving full tables) is logging:
MLSCEF-SP-7-FIB_EXCEPTION: FIB TCAM exception, Some entries will be
software switched
I have found that it is due to FIB TCAM overflowing. I have found that

Hi on a cisco 4507 of mine I am getting a lot of these messages:
%C4K_EBM-4-HOSTFLAPPING Host xx in vlan 1173 is flapping between port
Gi3/39 and port Po2
I know it means its seeing the same mac-address from two sources,