I have a router connected to corporate network then a 3560 switch. I
configured a VLAN with ip address 10.1.2.1/24. I configured fa0/1 with
ip address 200.1.1.2/24 (same subnet as my router). I set my default
route for my switch to be the ip of my router address.

I am eventually switching paths to the Inet.  I have a 2nd PIX
firewall and the connection has tested well through it.  Our net is
low on ips anyway(we have to use static IP), so I am going to put in a
new 2621 router and add a subnet.  Right now we have been using

I just switched from a T1 to Comcast HighSpeed Internet 16mb/6mb.  I
am using a Cisco PIX 515E as our firewall.  With the firewall in the
works between my laptop and Comcast I get at best 5mb/5mb speeds using
Speakeasy speed testing.  When I remove the PIX from the equation I

We are preparing new hw that will allow us to receive bgp routes –
currently we’re just broadcasting.
However, we know that our supervisor 32 engine does not have the
capability to receive the entire internet routing table.

is it right that the Pix or ASA doesn't support compression for ipsec?
Helmut

In my follow up about T1 bonding (3MB in specific), can I mixed 2
different WIC cards to be use on the same router (1720 or 2600 or
1841). For example, mixing the first WIC (WIC-1DSU-T1) and the second
WIC (WIC-1DSU-T1-V2) on the same router?

HI ,,, all.
Iam Cisco Certified Network Professional (CCNP). Iam seeking job now
so
I want  alist of cisco management utilities I know little of Them such

Need recommendation on which router to use:
Currently running a T1 line with Cisco 1720 router (32MB DRAM and 8MB
Flash) running IOS 12.2. Company planning on increasing the bandwidth
by bonding 2 T1s. Will the current 1720 router be resourcefully enough

Hi, All,
Today, I tested the "port-security" in cisco switch:
I configured a switch port with port-security with static mac-address,
after that configuration, I found the workstation can not get DHCP IP

Can anyone explain me what smtp fixup is usefull for ?
When will I have to activate it, what will it change ?
Sorry for this newbe questions
thanks a lot

From home, we use plain old home Netgear routers to connect up to the
net. We use our laptops and the Cisco VPN client to connect up to a
Cisco VPN Appliance in a data center and MS’s RDP to connect up to our
servers. This setup works perfectly. We use a PIX 501 from our office

if i configure rip on a 2821 box there`s not error message. But RIP
doesn't work, and the configured lines are not visible in the
configuration!?
Any Ideas?

We currently have a single Cisco Catalyst 4510 with dual supervior IV
modules and dual power supplied. It's central to our network with
workgroup switches and servers connecting to it.
My question is how internally redundant is a Cisco 4510?

Hi Group,
I have come across something I can't solve.
When using my Cisco as dns forwarder, DNS is just plain slow from my
PC, even when using openDNS in the Cisco (model 857)

ASA 5510 seems to work normaly but it restarts itself a dozen times a
day.
Does anyone have an idea what might cause this?
It is connected to an UPS so power failure should not be the cause.