I run into a problem when trying to use a radius server (on Solaris)
with ASA5540 for authentication (for RA vpn). In the appliance, I can
test it with:
# test aaa-server authentication my-aaa-gp host x.x.x.x username test

Hei
Can anybody help me, I want to tunnel my traffic in a MPLS, it's to
expensive to get dynamic routing running inside the MPLS. My connection is 1
Gigabit in both ends. I have tryed to set up a tunnel interface in 2 3560

I have been given a group of ip address from the service provider
and I want to be able to use these address directly and also have
anothe group of address which are being NATed is this posable

Have a 2621 running 12.3
Got a new set of IPs and serial line(T1)
from the console # prompt can't ping the first two
but can the last one, f0/1

All,
I have a 2811 with the advanced security feature pack. I'm configuring
it to replace our old pix and 2621 but I can't set the default route
to an "outside" interface (FastEthernet0/1), I can set it to an inside

Changed to T1 from ATT, tired of local (lack of) service.
have 2621 router running 12.3 and the old config is as follows
interface FastEthernet0/0
 description OUTSIDE INTERFACE TO THE INTERNET

Dear all, i just wanted to check what the source address of the IP
packet that is generated by a router configured with 'ip helper
A.B.C.D' on a local interface would be.
i need to know this as the router is connected via an IPSEC VPN

We are using a CISCO router (851) in Greenland to connect to be able
to connect from our facility in Colorado to a GPS receiver in
Greenland.  TeleGreenland charges a lot for a fixed IP address using a
ADSL modem, so we are trying to VPN to our facility using the CISCO

please does anyone have the factory default user & pwd for series 850
router? Can't find it anywhere and now locked out of router. What a
muppet!

i have some acl:
masterASA(config)# sh access-list deleteme
access-list deleteme; 4 elements
access-list deleteme line 1 standard permit host 10.1.20.11 (hitcnt=0)

Been having some issues with 2 aironet 1200's.. Now I am thinking
perhaps we are just asking too much out of these devices. We have 2
yagi antenna's mounted outside on the roof of both buildings.. Just
wondering if anyone has any thoughts at to what type of range we

Is there a way to easily get this information from a CAT switch:
switch name, MAC, vlan, shelf, slot, port
So basically, get the switch name, then enumerate all the MACs
"registered" and which vlan/shelf/slot/port the MAC is connected to.

I'm looking for some advice on a problem i have with a Cisco CSS and a
ISA 2004 server, the CSS is load balancing a web farm but one of the
servers is always getting hit and its not the same one after some
investigations we traced it back to the ISA and the VPN users that are

Good afternoon everyone,
I am having trouble setting up a simple failover configuration.
We have 2 connections (one is Fiber @ 10Mbit, other is ADSL @ 6Mbit).
The Fiber usage is expensive, so for client usage I was looking at

Is there any of Cisco feature that let me measure the amount of
network usage per user or per ip address.
For example: I have 10 computer on my LAN, what can i do if i want to
know, let say pc01 use how many Mb per period of time? Is it possible