I've forgotten the pre-shared-key needed to connect via VPN.
How do I change it via the CLI.
I entered the following command:  no pre-shared-key * so I could then
re-enter it but I received an error after the command.  Therefore, it

I would like to achieve redundancy but I was not able to understend
completely the topic:
I read this:
http://tcpmag.com/qanda/article.asp?EditorialsID=348

would an access list to open all traffic from the dmz network to
outside look like this
access-list dmz_access_outside extended permit ip object-group
company_dmz any

I posted a couple of weeks ago about EIGRP over MPLS. The scenario
that I was having problems with was balancing the traffic across two
T1s attached to two Cisco 3845s. We have HSRP for redundancy, but on a
suggestion from this group, I am pursuing configuring GLBP instead of

I just loaded a new IOS on my 2611 and it will not boot. I keep
getting the message '
open: file "n" not found
open(): Open Error = -1

Hi, does any know where to find a list of the feature set codes for
router IOS file names?  I have searched high and low and can’t seem to
find this.  You would think there would be a simple table somewhere.
Something akin to the table I have found in several places regarding

Hi guys n gal's
The issue I am having is that after we received one of the 2611's it
did not want to load and gave this message in a loop.
open: file "n" not found

I have a question regarding Cisco phones 7940/60 and dial maps.
The phones are SIP based and they are loading with dialplan.xml.
When dialing out digits are tested to dialmap/digitplan on the phone,
but my question is when returning a call from "Missed calls" menu can

I have logged in via Telnet on a brand new 857w router with the cisco
username (password:  cisco) but I havent created another user account.
The cisco username is no longer valid as it has expired after one use.
I need to reset my router back to default, so I can configure using

We have an IPSec tunnel required for a client to pass certain types of
traffic, but multicast must also be passed.
I stumbled across this from Cisco:
CSCdu87170

        I've been asked to look at a Pix cluster that didn't failover
properly when the master went down last.
One thing I noticed is that although the 'sho ip address' command
reveals  Current  Ip Addresses to be different to each other, both

When I was trying to connect the corporate network through vpn-client
I got the following message(in log):
21:31:06.609  04/27/08  Sev=Warning/2    CVPND/0xA3400011
Error -9 sending packet. Dst Addr: 0x4DFFFFFF, Src Addr: 0x4D330B74

Is there an IOS command to check what DRAM slots are currently being
used and how much DRAM is in them? The router currently has 96MB
installed and I need to get 128MB.
Thanks

Running Win XP SP2, I vpn to a remote server using Win XP
basic VPN connection and I RDP to a workstation using mstsc.
As soon as I install Cisco VPN Client Version 5.0.03.0530,
without even first rebooting the computer when prompted

my English is not best. I hope you could understand.
I had install a Windows Server 2003 Server for Radius. On Internet
Authentication Service I added Cisco 1131AG as Client...
My Windows XP Clients could connect to the Radius Server over the