Im trying to load an IOS on a 3620 and im wondering what do i type for
interface
im in config and i try to type interface but its wrong
what is it ?

I have a question concerning bgp multihop.  I have a dual homed( Both
peers reside with the same isp) bgp v4 configuration on a 7206 with
the following statement:
neighbor <neighbor peer B ip address> ebgp-multihop 255. The two peers

I have a C3620 (16F/64D) IOS 12.3(24) IP/FRW/IDS PLUS that is doing the
firewall /nat device for my lan.
My network is this:
Edge Router C2650

I wonder if anyone can assist with a BGP
understanding issue?
I have a lab setup with BGP and it seems that
I do not understand "bgp synchronisation".

I'd like to block traffic to my routers from outside my network; but
still to allow my routers to traceroute/ping to hosts outside my
network; and reply to traceroutes sourced outside the network.
Is there a way to force ICMP replies to come from a particular IP

For some reason, it's taking a long time for my pages to load. I think
the problem is that there is something wrong w/ my DNS servers because
the lookup takes almost a minute for each page I try to reach. My
previous firewall didn't have this problem.

I wonder, is it possible to configure different VLAN to talk to each
other without a Router? Is that possible by doing a layer 3 switch?
Thanks,

I have a new 5505 for my home but I do not have a machine w/ a serial
port or a usb adapter. My goal is to use the CLI from my linux box.
How do I configure ssh or telnet through the ASDM so that I can connect
and configure the device over my normal rj-45 lines? I enabled the

I configured ike sa keepalive timeout as 60 seconds & phase 1 rekey
interval as 60 seconds. Now this side is not getting any keepalives
from anyother router, so will the phase 1 rekey, or due to keepalive
timeout Phase 1 & phae 2 SAs should be deleted? I think since both

I have a 3550 and the customer that returned it said that port 7 was
bad. How exactly do i go about testing the port? any command that will
show the statuses of each port?
Thank You

I'm additing a router hop (for policy-based routing) to my network and
have a few questions...
First, the old config:
       T1-router-A

i am looking at a 7206 router configuration with the following
statement 'route-map ISP-IN permit 10'.  There is no information that
follows this for this route map(no match or set statements).  What
purpose can this serve.  Thanks

We've got hold of a few old dinosaurs that will still be useful to us,
some 2500's, some 4500's and a 2621.  I've been able to send a break
and go through the PW recovery sequence easily with some of them, but
a two of them -- specially a 2514 I'm working with right now -- just

Greeting,
I'm wondering if anyone can speak about their experiences with the
following vendors.  We are in the discovery phase for searching for a
vendor to provide a private MPLS network supplying throttled service

I just got back a Cisco 2621 and it tells me the following message
System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
TAC:Home:SW:IOS:Specials for info