I tried posting in the MRTG mailing list, but I didn't get a
response.  Are there any MRTG users out there who could help me with
graphing the utilization on a Multilinked Interface on a Ciosco 6509.
I've been using MRTG for my Cisco switch for a while.  All of my other

I'm looking over some subnet math and my brain is telling me there is
a problem, but the force is telling me otherwise.
My main question is: Can you have these two networks living together
and not overlap each other? Part of me says yes because the masks are

is there any document describing 7204vxr ipsec encryption performance,
depending on hw configuration?

Hi. We are having a problem with a 6509 and high cpu utilization.
The 6509 is running CAT OS, and running cat6000-sup2k8.8-2-2. The
issue is that the Switch will stop all telnet traffic to it as well as
kill to console connection. This lasts roughly 10 mins, once we gain

I need to connect two 2801 over fast ethernet with ipsec encryption.
I also need ospf so I configuring gre over ipsec:
crypto isakmp policy 15
encr 3des

I've configured an access point to use a Cisco ACS for RADIUS.  The
connection
uses MD5-Challenge, but when attempting to authenticate against a
Lotus LDAP- an error message is logged-

I have been asked to look into a network management system which
manages a lot  (100+ switches and 100+ routers) of cisco boxes.
The problem is that a lot of the cisco kit has the "wrong" IP
displayed for the chassis in the NMS.

We have been seeing very high CPU util values which reaches the top
(result of "sh processes cpu history " copied below). which were
reaching only to 40-50% a few months ago.
This is a router which has an ATM port with a connection of 16Mbps

My goal is to allow vpn dialup pptp connections into my internal
network.  I have put together the configuration below.  But, I am not
able to even connect.  Would anyone know what is wrong with the
configuration below.

If there is a hardware-based Linux iptables router, would it hurt
Cisco's business?

Is it possible to have 2 different enable passwords on cisco switch? I have
two different users that can log in but share the same enable password

HI, all
I've been hitting a weird problem when attemping to create a site to
site VPN connection between an ASA 5505 and a VPN 3030.  For some
reason, the IPSEC tunnel gets created, and I can see packets

I've just purchased a new ASA 5505 with a base license only.  I'm
planning on configuring and installing in a client's 10-20 user small
office.  Am I correct in seeing that this box will only allow 10
simultaneous Internet connections?  Here is a 'show ver':

What would cause this error?
What would cause this error in the event log?
Event Type: Error
Event Source: BBSM_Core

I have one C2811 running IOS 12.3(8)T10 and other C2811 running
Version 12.4(6)T5.
These 2 routers connect via an IPSec tunnel to the main site router.
The crypto configurations are basically the same on both C2811s.