I have new cisco switches...3560's and older 3coms superstack III and
II connected via crossover cables.
Can anyone advise on best practices for connecting the two? Should I
fix the port speed? etc..

We're using ACS 3.2 for AAA. There is a collection of .csv files in
the ACS which track "Failed Logins". I want to automatically access
and download that information for analysis. Is there an API available
to do this?  If not, any other ideas?

Rent A Cert, a good or bad idea for Cisco partners and cert holders?
http://www.networkworld.com/community/node/19970
Sincerely,
Brad Reese on Cisco

Hi, I'm having problem adding DHCP service to my existing network.  My
laptop is getting priviate IP assigned when plugged into FastEthernet4/0/0,
and I can ping them within network from my public subnet aa.bb.cc.0/20, but
I

Hey everyone,
I need to set an ip address on a t1 card that is in a 7200 running IOS
12.1(27b).
however..  I can not figure out which int it is.

I've configure a Cisco Call Manager to send outgoing calls to a a SIP
trunk (configured an outgoing dial-peer).
I'm trying to receive calls from the same SIP trunk, but I got 530
(internal error) on the SIP server that tries to send the call.

I currently use an 837. In addition to the dialer config, I have acl's, port
forwarding etc.
I've read that the 857 and 877 are 'fixed-configuration routers.' I'd like
to upgrade to one but need to be able to configure it via the IOS. '

I have cisco router running as DHCP server (12.2.(46)). It leases IP
addresses dynamically with no problem. However, when I try to configure
static binding , it does not work!
I tried both hardware-address and client-identification commands both of

There are two Cisco Aironet 350 Workgroup Bridge's used to bridge two
locations. One of them is now dead and has to be replaced. What is the
best sollution for replacing the 350 Bridge?
I was thinking about Aironet 1310. Is this the best solution? Can the

Have two 2924XL switches each with two X2931 GigabitEtheernet modules
and I fibre connection GigabitEthernet1/1 to same on other switch and
ditto for 2/1.  The lights are green on all but 2/1 on second switch
which is amber. looking at it, it says it is up recognizes the media,

I've got a web server farm set up behind a pair of LDR 416's in
failover mode.  LocalDirector 416 Version 4.2.4
there are 2 web servers, hp proliant DL360 G5 with 2 NetXtreme II
BCM5708 Gigabit Ethernet ports.

Guys
We have an issue with our wireless network I'd like to try and discuss and
learn a bit more about please.
Our staff are allowed wireless access to the network via MAC authentication

Hello gurus,
I need some help with a new project.  I've never used Cisco ASA
before, and I don't know how to set this up.
I have Cisco 3800, with interface gigabitethernet 0/0 configured with

One of my biz colleages has a Cisco 1231 wireless AP that they currently use
for the computers in the office.
They would like to have a separate network configured that would allow them
to grant access to visitors,

I have a general question here. I currently have a small business, and would
like to set up VPN on my network so as to be able to connect remotely.
Currently, I use comcast as my ISP, and looking to by a sonicwall firewall
both for security, but especially for VPN.