I am looking for a solution to get a graph for "sh ip bgp sum"  routes
into mrtg.
Any sugestion how?
Regards Jan Rockstedt

I have a Catalyst 5500 with a SUP2 and a Route Swtich Module. I am
using the NAT on the RSM to translate between our 192.168.1.0/24
network and our ISP IP address which is a Comcast cable modem. I have
everything working, except that I cannot VPN into my workplace. It

Please send me a sample of your access list and explain. Thank You
Katie Tam
Network Administrator
http://www.linkwaves.com/main.asp

I just switched over to a Cisco PIX 501 firewall from a linksys
router. Before, port forwarding was very simple for me. Now, I've
spent 2 hours trying to figure this one out. I do not have experience
with Cisco console commands, so please gear any responses toward the

I read http://www.cisco.com/warp/public/473/21.html#pracex
and http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_4_2/config/vlans
.htm#xtocid798015
twice and just want to run this by you guys to see if I understood it.
1. If two switches are set as server with VTP ...

Either a link to a how-to site or direct info on how to make this
happen would be appreciated.
I need to configure 4 VLANs on the aforementioned switch from scratch,
and I am having little to know luck in making it happen.

on my cisco pix 525 i have installed one fibre optic in gigabit and it
works fine.
Now i would like to migrate my infrastructure to copper wire, but i
see on cisco web site that there is not any nic 1000T support by cisco

Hi, all
Does anyone know of a link on Cisco's site that explains how to
perform an IOS upgrade (all the steps) for a Catalyst 6500 switch with
a Sup2 card (any kind), and an MSFC card?

What tool commercial or freeware you would recommended  to monitor
utilization - throughput on Cisco 3750 and 4006 switches
Thanaks

ios 12.2(17r)S2(Fc1)
hi,
i am beginner
i wish interconnect two 6500 router by gigabit ethernet with no ip address

 If each router is configured to use key chain to authenticate each
other, must both key-id and key-string be same?
 For example, R1 --------------- R2.
 On R1: (key1=abc, key2=def, key3=xyz)

I'm looking at this pdf
http://www.cisco.com/warp/public/765/tools/quickreference/routerperformance.pdf
I'm looking to buy a couple of used routers on eBay but I don't want to
buy more than I need, or mislead myself into thinking one will be

We had an FVS318 behind a Cisco 1605 and it worked fine. A few days back, we
fired up a new Cisco 1800 on a new T1, moved the Netgear over, and now I
can't get my vpn tunnels to talk. The new T1 is on the same network we
switched all our buildings over to, and the Netgears work fine ...

on a cat 2950 with a ios version 12.1(22)EA9 the port goes into the
error-disabled status and I don't know what's the reason...
There is no special config on the gig0/1 port which is the uplink ....
any help for me ? thanks

Hi, do you know radius server for Cisco Asa with temporary account
generator?
I need to use it in Internet Cafè.
Thanks!