I know that the WIC-4ESW was designed for 1700's, so I'm wondering if
anyone knows if it will work in a 2600?

I have a t1 and a dsl line with static ip
I have a firewall connected to the t1 that does all my NAT and is
setup in as the network gateway.int address 10.100.10.254
my dsl router is connected in parrallel with the firewall and has a

i have in my possession a cisco ubr924 cable modem router and am
wondering if it is good enough to study for ccna? I do not actually
have cable at my home, I use DSL but Ill just take off the default
bridging and set it to act like a regular router. buying more hardware

How do you bring UP an SFP interface on a 3750G? I have a VLAN 5 setup
for it that I want this interface to go through... Can't seem to work
at the moment.
Thanks!

I have two internal routers with a serial interface connected to a "public"
network (indeed it is the Internet but ISP allows communication only between
two routers).
As a backup link, I have to configure a GRE/IPSEC tunnel between routers,

I'm having an issue that I'm trying to solve.  The pieces of the
puzzle are:
Microsoft Exchange 2003
Cisco Pix 515

hi i have 2 router on router1 i set this
isdn switch-type basic-net3
interface BRI0/1/0
ip address 10.10.0.1 255.255.255.0

Having a problem with Pix515E that I just configured where I can't
ping nodes on LAN from the pix and vice versa. Pix has an outside
interface which is plugged in, the additional interface is not plugged
in and not being used, and there is a built in 4 port switch on the

I have an internal FTP server on 192.168.1.2. It is configurated to use
SSL. It works fine on the internal local network but not from the outside.
My passive port range is: 2048 --> 3000
What am I missing in my configuration?

Thanks for the replies!  
I guess I need to narrow my attention a little and break this up so I
can relly understand what is happening...
So please, let's forget about the dlink router for a minute. (If we can anway)

Can anybody tell me abt the help/tutorial on CISCO 10K series sho atm
commands and their corresponding matching OIDs ?
Thx in advance

I am looking at purchasing an ASA5505 firewall - the main reason is to
take advantage of the VPN connectivity of the device, but I have a
couple of questions:
1.  Does the device support IPV6 natively, and has anyone used it

Original Post:
Hello everyone..
I have a 3620 router in my home that I am using to study for my CCNA exam.  
I have 1 ethernet port 'ethernet0/1' connected to a 2924 switch, then my pc (192.168.3.2).

Hello everyone..
I have a 3620 router in my home that I am using to study for my CCNA exam.  
I have 1 ethernet port 'ethernet0/1' connected to a 2924 switch, then my pc (192.168.3.2).
  (e0/0 - Ip address 192.168.1.3)

I need to NAT a range of ports into a local IP. port 2048 -> 3000 to
192.168.1.2.
What is the best way to do this om a ASA5505?
This does not work: