We are planing to buy two ASA 5520 for Active/Active link Load
Balancing Configuration. Any one has Cisco Link for such Configuration
Example. I only find PIX/ASA 7.x Active/Standby Failover Configuration
Example:

Have a 2600 router with a T1 coming in, with only 256k of bandwidth being
sent on the T1.
Basically I am using only 4 DS0's from a t1 out of a multiplexer going to
this router. The T1 interface of the router continues to reset itself.

I need OID for ASA (sw. version 7.2) for CPU utilization readings. Anyone
knows which it is?
Best regards,
Igor

How many different ways can you reload a config on an ASA device from
a remote location?

Hi Group,
I need information about a replacement product for the cisco 2511 with
16 x RJ45
Which one can I use ? In the cisco doc I found as replacement the

Hi to all
I would know differences ( advantages and disadvantages) , talking about
multilayer switching on a Cisco 6500, , between routed interface and SVI
(switched virtual interface)

IS there someone who knows what is an "explorer storm"?
thanx

I have a 2811 where 1 int has an internal IP and the other has a
public IP. The serial port brings a T1 in.
I would like certain addresses that are internal to be routed to the
interface which has a LAN IP.

I want to be able to redirect all outbound web traffic (except the
proxy address) to an internal web server from the Pix 525 firewall.
So the end result will be if a internal user tries to bypass the
proxy, the firewall will forward them to a web server saying the proxy

I have my cisco ASA logging to a syslog server.  Is there a way for
the ASA to find resolve the websites that the users are visiting
(instead of IPs, actual DNS names)?  Also, is there a way for it to
track the user who is accessing it instead of the workstation and IP?

I'm a newbie,
I have a Cisco Asa 5510,
I need that an ip on the DMZ net can communicate with a LAN IP on one
port..

I am trying toget a Cisco 877 router working on my Demon B'band connection.
The Broadband works when I use a  BT Voyager 220V so I know the service
itself is OK.  The configuration on the router works quite happily when
attached to a standard BT B'band connection at another site.

This is what I would like to do:
I have two vpngroups (A and B) created on the PIX. I want the A group
to authenticate via Radius to Server A and the B group to authenticate
to Server B (also via Radius)

I am a newbie.
We use a PIX 506E in my LAN to access Internet using 1 public IP.
I wish to NAT another public IP to my computers's private IP to be
able to use P2P and be like I had a public IP. I can do this with a

   I have a cisco 515E with an unrestricted licence and extra 4 port
board. I just wondering if somebody could give me a pointer on how to
setup a NAT for my scenario.
What I have is four internal host which each need to be nat'd to four