I have a 515E that, according to the quick start guide, should allow
out of the box https configuration.  The DHCP server is supposed to be
operational as well.  However, I am only able to connect to the 515E
via a serial connection.  I can tell that the DHCP server is enabled,

I have a contract coming up on a FE connection to the Internet with
full BGP routing table.  Wondered if anyone had any thoughts on price
or perferformance for ISPs these days. It's been a while since I've
gone shopping and I'm still not sure if I'll take it out to bid.

Folks:
My personal email address is larlee23@yahoo.com    Here is a list of my
equipment along with prices.
I have some excess CISCO gear sitting idly in my basement.  The recipient

I know you can nat all traffic on a port from outside to inside.
ip nat inside source static udp 10.0.0.5 3389 200.100.200.111 3389
extendable
What I would like to do it take a specific external ip (153.56.10.25)

Hi, I would like to find out what the virtual-dot11radio is for and how
it can be used.
Also I am interested in knowing if I can change the native VLAN from 1
to 2 since we use foundry equipment and our native vlan is 2.

I have a PIX 515, one site is connected via VPN as 192.168.192.0/24
Client connects to the same PIX and gets an address from this range
192.168.255.0/24
I can't ping from 192.168.254.0/24 to 192.168.192.0/24 or vice versa.

I'm working on a merger project and on one side there are quite old
boxes like 2924XL and 3640 with ancient firwmare. Tried contacting
local Cisco dealers to find how I can get support (smartnet I think)
for these devices, but always ended listening to a sales blurb for new

I have a 4506 switch and a 4503 switch.
the 4506 switch has already been configured with ip address etc and the
config I want.
I want to be able to copy the config file and put it on the 4503.

We are using RADIUS under AIX to authenticate traffic through a Cisco
box into a VLAN.
Can the RADIUS server be configured to not authenticate specific IP
addresses?

is IOS a custom OS or is it based on VXWorks or an other embedded System
like that ?

NEED HELP ????
Setup is as follows:-
Internet---PIX----Cisco4500-----LAN
I need LAN users to resolve internet DNS query using local DNS Server.

We are considering moving to BGP on our border Internet router. It
would have two full load-balanced DS3 connections to our upstream
provider. Would a Cisco 7206VXR with an NPE-400 and 512MB RAM be
sufficient horsepower?

I have a webserver in my dmz (192.168.11.10), it is accessible from outside:
static (dmz,outside) 1.2.3.4 192.168.11.10 netmask 255.255.255.255
nat (dmz) 1 192.168.11.0 255.255.255.0
access-list acl_out extended permit tcp any host 1.2.3.4 eq www

Hello every one!
I have a problem sending faxes through VoIP
This is what we have:
PBX with VoIP Card --- Cisco --- E1 --- (Internet VPN) --- T1--- Cisco

More than 64 Vlan has been created in my VTP domain.
The 2950’s has a limit of 64 PVSTs.
On each 2950 on my network, how to limit the PVST to only vlans that are
switching traffic for (like pruning vlan). How to configure them ?