I am trying to find out if I can NAT to different "outside" interfaces
based on the destination port and/or destination address specified by a
machine on the inside.  (What I've read so far in the PIX documentation
hasn't shed enough light on this for me.)

I had the requirement (maybe wrong) to configure a 7604 with 4
powersupplies. Is this possible ? For my understand I can only 2
install also for 7606 !?
Udo

I am looking at a list of CISCO routers and switches generated by a an
inventory script.
One of the categories is NonRoutingSwitches, which includes cat 35xx's.
I am not sure about this "NonRoutingSwitches".

We are researching the info for a VoIP solution.
In reviewing the information, we recently discovered
there may be various challenges with running VoIP vendor apps
with a Citrix based network.

can anyone give me any tips on doing traffic shaping for our old 2620
router.  what i'd like to do is to prevent one protocol (smtp) from using up
all bandwidth on the serial0 (leased line).
our line mainly services dns, web and email (exchange2003).  once in a

Here is my Situation.
I followed the Cisco Docs about creating a firewall. I got the inspect
rules in place and working  but the access list is giving me a problem.
When there is no access list applied to my outside WAN interface, I can

I have a Cisco 2800 that is being used as a firewall.  When I am behind
it and NATing to the Internet I am unable to VPN out to any VPN servers
because IPsec does not go accoss a NAT with out port forwarding.  I am
trying to find out how to turn on port forwarding so that I can VPN ...

I have a router which is connected to a firewall.  Here is
where I want the NAT and VPNs to terminate.  I am having trouble
figuring out how to set this up.
If I have NAT at the firewall then information has to get from the

Help..
I've been reading thru these groups, google-ing and reading anything I
can.
I cannot get RDP to work theu a PIX

Hi, would someone please give me a pointer in the correct direction?
I would like to think that I'm a fairly experienced Linux IPTables user,
but I am a novice when it comes to Cisco IOS and NATing.  I have a Cisco
Catalyst 5000 Route Switch Module (based on the 7000? router) that I ...

Could anyone help me.  I currently own a warehouse of 10,000sq/ft with
a height of 6ft.  It is completely racked out with metal longspan
racking with boxes on.  I am looking to introduce a wireless setup with
in the warehouse so that we can work within it with our Symbol MC9090

I have two Aironet 1240 APs. One of them is installed in a vehicle,
which also contains several wireless clients. The other AP is
stationary and is connected to a server over a wired LAN.
I need to configure the APs so that the clients inside the vehicle

My technicians have reported difficulty using any of several toner/wand
sets trying to find ports on Cisco gig switches.  It seems that the
tone becomes inaudible, or shunts/dies after a few seconds.  However,
if they use the 'toner' function from one of the Fluke meters, they can

I is possible to configure a ASA5520 with ASDM 5.0 to NAT an internal IP
adress to many external shifting IPs sequentially?
That is have for instance the internal address a.a.a.a make one session
through the firewall natting it to b.b.b.b, the next session automaticall to

We are using 3560 and 3750 PoE switches in a network which
interconnects a lot of clients using a proprietary VoIP software
solution.
This Software uses Multicast groups for communication and now we are