I am having Cisco 6000 series switch .I am getting this Error Message
on Console:
PC = 0xbfc034cc. Cause = 0x4000, Stastus Reg = 0x3041c003
ROM Monitor Can Not Recover From Exception

Hello, I have an entry level question regarding static routing, looked
all over the net and could not find a clear answer. Maybe the smart
folks here can give me a hand.
Using Static Routing table, point to two gateway routers (A and B).

Hello, here is the scenario,
Site in Paris:
external IP of the PIX: 195.238.14.14/28
internal IP of the PIX 192.168.10.1/25

I currently am in the process of evaluating our best option for
upgrading our deprived network infrastructure.
We currently have approx 30 24 port 3com unmanaged switches.  Our
network / company is growing a lot, and they are not cutting it any

My 4510 switch stops responding over the weekend. No users in the
office that day so no complains about conenctivity. I can't telnet to
it, can't ping it. I can ping loopback0 but no telnet allowed though.
CDP works fine, can see the switch from the directly connected neighbor

Guys, is there a Subnet Mask for Class D, amd E?

I'm trying to set up my PIX to allow people to pc-anywhere in to a
specific PC.
Here's what I believe to be the relevant parts from my running config:
access-list outside_access_in permit tcp any host xx.xxx.xxx.xx eq

I need to enable HSRP across two core 6513. We need this for two voice
gateways so there will be 2 HSRP groups. Most of  the cisco
documentation I have come across is for MFSC redunancy. Is it better to
enable HSRP via VLAN interfaces and add the switch port to the VLAN's

I have many Catalyst switches that I am polling with SNMP. I am trying
to find what ports are acting as trunks.
On most of the switches it works properly, using
vlanTrunkPortDynamicStatus.

My company is using two PIX 501 and establish the VPN connection
between two office. Now one of office is changed to use the other ISP
and of course the fixed IP is changed also. Would anyone tell me how
can I change the configuration to make the VPN connection work?

I'm using two 2811 routers to create a network to network GRE IPSec VPN
using shared keys and esp-3des to encrypt traffic.  When I transfer a
very large file across the VPN tunnel the transfer takes place at
around 40Mbps (the physical connection between the routers is currently

I am hoping someone can critique this.
I am in the process of switching ISPs, as one of them has lots of
outage issues.
I have a 2620 router with 2 T1 WICS in it.

Can someone please explain a few details about my show interfaces
output?
It is a Cisco 800 series that operates as a DSL modem.
What do each of the interfaces mean?

I am trying to swap a faulty Cisco 828 - did a TFTP backup of the running
config and put the new cisco in.
But it does not come up - I was expecting that you would be able to telnet
to 10.10.10.1 and then do a copy tftp running-config - but I am not able to

Running VMS cluster over 2900XL switch, recently added
SAN with 1 Gbit fibre.  I note that the 1 Gigabit TCP/IP interface
is the same connector as the GBIC modules.  Can this be made to talk
to a Brocade SAN switch over SC/IP?