I have four devices, that I need to segregate..A,B,C,D
Will this work::
VLAN 1
A+B

I have classic static NAT, two interfaces, outside, inside. I NAT
A1 - B1
A2 - B2
but I need one address to pass through without NAT. How can I do that? If

I have an E1 PRI plugged into a cisco 5350. There are
no other circuits attached to the router. The clock
source is set to the line, and the tdm bus is set to
use this port.

Is it possible to gather existing groups in a upper level group (group of group)?
It would be fine.
Alex.

  Hi gents, I have a problem with my pix, it has vpn tunnels
configured, and I'm trying to configure a vpn client, I've done this in
other pix without any problem , but it seems I forgot something and
here it doesn't work.

Iam New into the network ,can u help me calculating the below mentioned
request
how this is calculated  "BW Util has exceeded the threshold value of
60%,The present   value is 62% -"

hi guys...
is there any possibility to read the serial number of an installad gbic
or sfp when connected to the machine via telnet/console?
thanks in advance...

Can anyone help me to understand sourse based routing and why it is
mainly used for.
Warm Regards,
Bhaskar Desai

I have two 4500's which I tried to RSPAN between.
This failed.
Ports Gi 1/2 on each switch connects the two switches.
STP has a root and a non root on this VLAN which

Hi - I'm hoping someone can help - I'm new to Cisco routers - however am
familiar with other more advanced routers such as Sonicwalls.
I am using SDM and cannot find anywhere that lists the MAC or Physical
address of port:  FastEthernet0.

I'm setting up a network between the US and a European location. At the
Euro location I'd like to have 1 router (don't know which model yet)
with links to 2 different ISPs for redundancy. However the Euro ISP's
have already told me that I can't do BGP. Is there a another protocol

How can I disable inbound ICMP to a PIX 506 6.3(4)?
Are there any rules of thumb for the SNMP community string?  Should it
be a strong password string?  If SNMP is disable - is logging for the
PIX disabled too?

Hi, I'm new to Cisco.
Anyone know if the external interface on the NAM module can be used to
access
router configuration mode, that is, can I use the CLI command set.

After moving my CiscoWorks installation, (backup,. uninstall, install
on server, restore) I have lost some functionality. In the Device
Centre, the device selector says, "No applications or devices found"
plus the summary only contains the IP address and type and there are no

Ive bought a Cisco 1605R to replace my router (a cheap D-Link)
I had problem with the router and got this new one cheap.
The router is going to be connected to a cabel modem, that has dynamic IP.
The router is running with IOS version 11.2(9)P (Image file: