I've been trying to find a way to bond multiple T1s together, and had
basically written it off as not doable in our specific situation.  In
short, we're selling Covad T1s, so I'll give a brief overview of how
they deliver that service:

Can anyone see any reason why the below configuration won't work
correctly? I thought it was the configuration I used fine for a week
but when I came in one morning all the ports were in stealth mode
instead of open. I can't seem to figure out the problem.

I am searching for the MIB for the router 2811 from
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
but I could not find anything for this router.
Which MIB can I use for that router ?

In an ospf network do routers in the same area need to have the same
spf timers setting?  Or can a set of routers that need quicker
convergence have their timer spf set independent of the rest of the
area?

Hey all -
Does Cisco offer anything similar to the functionality offered on a
Tasman Networks box that would allow me to bridge VLANs across a serial
interface? Basically I'm trying to make a T1 an ethernet segment so

I have just replaced my 837 and AP350 with an integrated 877W and it all
works fine except that I can no longer ping or communicate between any two
wireless hosts.  Wired LAN devices can ping wireless devices and wireless
devices can ping wired LAN devices.

Can anyone give the details about the Dialing a router from remote area
with the use of AUX Port .
Thanks in advance .
Regards

We have all swicthes in a private subnet and currently the router holds an
IP address for these swicthes so they are reachable form the router on the
primary interface which is for public access.
I thought it made sense to put the private IP for the switches in a loopback

Just a quick question...
I'm trying to use the inbuilt tftp-server on my cisco router, and I'm
currently having some issues.
Reading files from the tftp-server works fine, but I cannot write

I have this problem with this vpn access
I am using vpn access to login into a customersite
using cisco vpn client
when I do that I lose my company's outlook email so I have

Ladies and Gents I need some help.  I know Cisco switches, 6500 series,
RSMs, Cisco APs and 3000 series Concentrators pretty well, but this Pix
Firewall/VPN is kicking my butt.  I have no experience with firewalls
and very limited experience with ACLs.  Please help, I have searched

    Can anyone point me to documentation concerning assigning an ip subnet to a vlan?
    Thanks,
    David

I have setup a complicated network as the following:
(SiteA)PIX506E  ---> (SiteB)[PIX515E + Router1 ] ----> SiteC[Router2 +
LAN ]
1. SiteA + SiteB = VPN Tunnel

hi all..
i have implemented qos for telnet traffic i.e. telent traffic use 32
kbps of guaranteed bandwith...
i want to know how can i check this implementation...

Has anyone had experience using the storm-control features on 2950s or
other Catalyst switches?  I would like to implement protection of
unicast, broadcast and multicast "floods" but am not sure what level
would be recommened.