I have a problem route my internal networks.
The setup is :
Local LAN 192.168.1.0/24 default GW 192.168.1.1
Pix ip : 192.168.1.1

I have an 3620 with old rom and it does not have the command tftpdnld.
I am transferring a 15M ios to the router via xmodem and hyperterminal
says it needs five more hours to finish the upload.
Is there any tftp client for Cisco router  that I can upload to the

I am creating a two unit stack consisting of one 3750-24TS and one
3750G-24T.  Should I use one stackwise cable or two?  Creating a "ring"
of two units seems odd, but I get the impression from the documentation
(nowhere spelled out that I have been able to find, but that is

I have always been of the understanding that whenever you connect two
switches / hubs a cross over cable is required. Can someone explain how
"Auto MDI/MDI-X" works and what it stands for. We use the Cisco
Catilyst 3550 and have always used crossover cables to interlink them.

Question,  Which would be easier, setup static routes in the PIX and
router behind the PIX or setup GRE tunnel and use eigrp to establish
routes and just insert the DO NOT NAT on the pix?
PC

was playing round on a ASA 5510 using the ASDM which wrote:
static (dmz,outside) 40.1.1.4 40.1.1.4 netmask 255.255.255.255
This takes me by surprise, as it's not in keeping with the syntax I learned
for the PIX, and indeed when I tried to write more PIX like static's via

I'm trying to backup a T1 connection with a DSL interface.  I already
found that the DSL is training fine, but because the DSL is provided by
a different provider, I am wondering how I can use NAT to map the same
inside IPs on the backup interface.

This may be a simple question, but I can't find it in my documentation!
How do I remove or delete a static route from my 837?
Regards
SW

I have a DMZ.   It is a 2950T hanging off of a firewall interface.   I
have another 2950T hanging off of that with a wireless access point on
it.
What I want to do, and haven't quite figured out yet, is:

can't seem to get secure shell working ; have a PIX  and Putty.
ssh 0.0.0.0 0.0.0.0 outside
ssh timeout 20
I have Putty hit the outside IP of the PIX and I get  " Server unexpectedly

Can Cisco Secure for UNIX integrate with Active Directory???!

Looking for a way to capture the hardware age via snmp or show
commands. I understand that asset management would be a "good" way to
do this. Looking for identifying all the legacy gear placed in service
before managing inventory.

How do i increase the PPP keepalive retries before the PPP server
brings the connection down? I am using a cisco 2610 router (IOS 12.3).
I'm able to increase the keepalive interval using the keepalive command
but not able to increase the retry count. By default its taking a value

 I'd like to convert snmp octets to decimal. Can anybody help me?
example:
ifInOctets.20 = Counter32: 773357035
what is the equation to convert that number to decimal.

I've been researching various implementations of VPNs with digital
certs and can't find a solution for my environment.  For a VPN, I have
two PIXs, each with one Windows 2003 server behind it.  These servers
can be set up as independent CAs since there is no root here. I want to