On the pix, and Im using preshared keys ok. I type in isakmp key test
address 10.10.10.10 netmask 255.255.255.255 when i do a sh run under that
line all i get is isakmp key ******** address 10.10.10.10 netmask
255.255.255.255

Will some one send me Cisco network Assistant???

I have a laptop with the LMC352 PCMCIA wifi adapter.
It all works fine, but I find that when there is an AP within range
that uses WEP, and I don't have the WEP key for it (usually the case!)
the adapter turns off its radio (the icon turns white).

I have a 1924 switch that is currently running v5.34.
       Catalyst 1900 - Firmware Configuration
    -----------------System Information------------
    FLASH:  1024K bytes

I have a router at the main office with static routes to another
location. I am using Frame Relay to that location and I also have
another static route to that location using DSL. The original config
was set up using two diffrent networks and if one failed I would have

I want to document my home network and have the capability to change
diagrams as the network grows and changes.  What is the best program to
use for this?  I'm really looking for a FREE program, but would be
willing to pay some money if the quality is significantly better.

I am having a problem with terminating VPN client on pix 515E (Version
6.3(4)) on dmz interface that has a public IP address. I allowed esp and udp
500 (isakmp) from outside int to dmz (I even tested with everything
allowed). In front of the pix I have internet router, and ...

I'm trying to PCAnywhere to one of our servers from outside the
network. There is a translation set up on the PIX for the server to
give it the following IP's;
Internal: 192.168.1.1

I have "dialer caller" commands in my Cisco ISDN PRI configuration that
are
supposed to assign IP addresses depending on the caller id. If no
dialer caller matches, there is a general profile ("dialer caller x")

Can any one tell me how to Copy A Host file from one router to another
router ??

(originaly posted at alt.certification.cisco)
My CCNP expires Oct 2006.
I got it through the 640 series exams.
Is it worth getting the 642 series study guides now?

I have set up a IPsec tunnel between 2 Pix 501.
I have accepted ICMP for both interface.
I have opened up the firewall inside and outside to ICMP and IP flux
from anywhere to anywhere.

we have a 801 cisco router. now we have 2 persons, who want to call into it
(ISDN), at the same time.
but after the first one is connected, the second one got an modem-error.
maybe we must configure something special to got it to work?

How to create vpn ipsec tunnel from another site with dynamic ip?

I just set up reverse telnet on my 2509 to connect to 3 switches and 5
routers. I can access each router OK but none of the switches. Is there
something extra I should do for the switches? They are all 1900s.
Thanks,