Summary:
- I switched ISP's in one location
- I expanded that same network to a larger subnet
- I upgraded both PIX units to the 6.3(4) firmware

I've recently brought an old Cisco AGS+ router on-line. It's running IOS
10 right now, and I'm trying to upgrade it to something a little less
ancient. According to Cisco's web site, IOS 11.0 is the last version of IOS
to support the AGS+, so I downloaded that image (gs3-k-mz ...

garnet
613.740.5949 x8023 (M-F 7-3)
sellingcisco@rogers.com
1 x Cisco 1750-2v ($675US =  $877Can)

  Does anyone can tell me what is the reason why cisco ACL only
support inbound direction in Layer2 interface?
thanks.
livan.

I apologize for high number of questions I'm posting these days.
I read 837's manual and it says I should use a particular cable (not the console's one) to connect an analog modem
directly to the console port. It suggest me to contact the vendor.
Which cable it refers to? Does ...

I need an ethernet-to-ethernet router which does stateless port/ip
translation. That is, the router should have a set of internal addresses and
a set of external addresses. The router is then given static rules of the
form:

Hello...
I've just received a new Cisco 1721/WIC-1SHSDL-V2 Bundle.
Unfortunately, the WIC-1SHSDL-V2 is NOT recognised. I already tried
updating to the most current IOS release 12.3.12. I tried IP, IP/ADSL

I hoping someone could help.  Is an access-group command necessary for
ACLs to work?  Hypothetically, if you have a bunch of ACLs but not
bound to an interface then the ACLs will just work as written to all
traffic versus if you specified an interface with the access-group

From my ISP I have a working connection via cable modem, which provides
a fixed, external IP e.g.
    212.47.11.123, gateway 212.47.11.1
Now I got an additional block of 8 external IPs e.g.

our PIX has two interfaces on the internet side. The first has 217.x.y.z while the second one has 151.x.y.z.
In log messages I receive a lot of warnings as I reported in th subject. One of these must accept VPN connections
I know these messages are generated by spoofing actions. Is ...

I'm trying to use both PDM and CLI on our PIX and to understand the corrispondence between PDM's output and "wr term"'s
output.
Does anyone know how "translation exemption rules" are visualized by CLI or how to send an "translation exemption rule"
via the CLI?

I'd like to implement a simple priority-based queueing scheme on a GRE
tunnel (e.g. making all telnet traffic higher priority than any other
traffic), but unfortunately GRE tunnels don't allow the use of priority-list/
priority-group.  So: what's the simplest alternative to achieve ...

I have several backup client in separate VLAN. All connected via CISCO
switch and router.
I intended to create a backup VLAN for all clients.
I have security concern as these VLANs should not talk to each other

Does anything need to be done to allow an IPSec tunnel from a PC inside the
pix run PAT. I have a PC trying to open a  tunnel to a linksys WRV54G at
another location. Linksys have a small client that is loaded on a PC and I'm
having trouble connecting to it from inside a PIX.

I have a router that has a VPN connection to remote site, I have to
monitor the state of this connection constanly. The only possible way
for me to monitor this router is by SNMP polling. The routers IOS
version is  12.2