I want to know the bandwidth limit which the Cisco1721 & Cisco 2600 can handle?

What type of access lists are available to me with the 12.1(19)EA1d
software(and SMI image)? Port ACL, Router ACL, VLAN ACL/Maps, Named,
standard / extended?
TIA for any insight.

I have a several Cisco routers which they are configured by some of my
employees, I need a way to know each command when it is added to the
configuration of these routers to be recorded by whom add it & at
which time & the syntax of the command?

I've got a Cisco 2900XL switch with three VLAN's on it.
I've got a DHCP server that lives in VLAN1 and I'll have clients on VLAN's 2 &
3. So far, I've not been able to get client machines on VLAN's 2 & 3 to pick up
IP addresses from the DHCP server on VLAN 1.

Is there any graphical tool, web interface or similar, which can help
me in configure our two Cisco 760 Series ISDN boxes?
I need to configure a clean bridging setup where box nr 1 calls the
other box throw ISDN, but since I am new to Cisco routers it would be

when having vpn established through internet between branch offices, is it
possible to have vpn tunnel *compressed*?
i mean, since traffic is slowing down through internet [256k link] it would
be usefull if tunnel is makong compression/decompression of content being

The router boots up but stays at this screen
System Bootstrap, Version 5.2(8a), RELEASE SOFTWARE
Copyright (c) 1986-1995 by cisco Systems
2500 processor with 16384 Kbytes of main memory

I'm working through an issue and I'm caught up on something I'm not
sure about.
Consider the relevant configuration clippings for a NAT setup:
interface Ethernet4/0

All the sites want to go to internet must go through HQ whereby HQ is
providing the internet connection through ISP A. At PE1, we set the
"default information originate". In this case, all the routes for this
customers sites will see the routes 0.0.0.0 via HQ.

I have a situation where we need to put in some fairly inexpensive
switches which must support rate limiting/shaping on a per port basis.
I'm using cisco for most of my network so I'd prefer to use cisco switches.
Do the 2950's allow you to rate limit/shape per port - even per ...

I need to reload the IOS Software can someone give me a link to somewhere I
can download.  I also need install instructions.
Thanks,
I'm Deep Water

    Can someone remind me what the commands are to disable the
lookup when you mistype something?  I know it is supposed to resolve
an unrecognized command to an IP address and telnet to it, but it is a
feature that I really don't need to have and is annoying.  

Hi guys, I'm new to posting here but hopefully somebody could help me
with a
problem I'm having
I have a Cisco 6160 DSLAM with a DS3-NI2 which is connected to a Fore

We have been working on our case study for CCNA 4, and we are assigned
to put frame-relay as the encapsulation type on all the routers, and
NAT on the router that the main offce's hosts are going to use. We are
using CCNA 3's case study, but we are just incorperating CCNA 4's case

I am working on a project where I am connecting two agencies. Each agency
has 20+ routers. One runs RIP v1, the other EIGRP. They will be connecting
together via two PtP T1's.   Each T1 is located at a different site. One T1
is going to be the preferred path, the other is simply ...