What's a good terminal/comm server product that would allow me to dial
into a single phone number, and control the consoles of up to 8
routers for remote management?
Thanks.

Hi,
I need some information regarding the ATM OAM behaviour on the Cisco
MGX 8850 switch, as I don't have the switch right now in my
possession.

I'd like to apply LLQ or CBWFQ on a 831 but my IOS does'nt recognize the
command "policy-map".
The command "class-map" and "service-policy" are well recongnized but
without policy-map I can do nothing.

When all else fails, I turn to usenet.  I would like to use my Cisco
2514 router to replace the Linksys BEFX41 Firewall VPN Point Router
which is the border router between my company's LAN and the ISP.  In
order to pull this off, I have to setup the 2514 to do NAT and PAT,

I am getting the strangest occurrences.  I have a managed IPVPN
network through a major ISP and it seems that something is bringing
down each remote IPVPN site we have in a certain order by ip-address.
What could be causing this?  We hooked up a sniffer on our local

I was wondering if there is a way to find out the software version
number with a Cisco 501 if you don't know any passwords.
The reason I am asking is in the situation when you have to reset the
password by uploading the appropriate bin file that depends on the

we are getting a 6509 with sup.720. I am just wonderig if we should
load CatOS on it or go with IOS.
The switch is going to be housing some 20 vlans (IP only) and not do
much of anything else (no BGP, OSPF, IPX or anything) besides acting

I have a PIX 501 and tried to install it - I get a steady green blinking
LED
on port 0 LINK/ACT. I assume this is some kind of error message as I get
no

What kind of port mirroring is available on a Cisco 2950 ?
I mean :
- is it possible to mirror a single port ? (I guess yes)
- is it possible to mirror a VLAN ?

I have search cisco support for days now and can't get a decent
example of the proper way to do it.
I can get it to work on a lan but as soon as I use public addresses I
doesn't work.

I have a very strange problem with a Cisco Catalyst 3550 which seems to
stop forwarding IPX routes to one of the Netware servers connected to
it. If the routing tables on the server are flushed, then the server
will populate a full IPX routing table. But after five minutes or so, ...

Websense gets me crazy, here is a brief background...
In our setup we have the following
Websense Policy server ---      Firewall (NAT)      ---  Internet ---
Gateway --- Websense Manager

Considering this:
http://www.routersim.com/detail.aspx?ID=32
Any good? Any reviews?
--

I need to create a static NAT for give access to one internal IP and PORT. I
have a Pix 515
But I need that the person who will access to the public IP:PORT must
aunthenticate with a RADIUS Server first

In securing an outside router, what is the most effective ordering for
your access list entries.  Does using the ACL entry with "established"
automatically defeat other entries since it only allows sessions
initiated on the inside?