I've got to configure lots of source-routing entries. They will have very
low traffic. I see that policy-routing is now supported through CEF or
fast-switching, so I think there will be no problems with router
performance. But I wonder if there is a maximum number of route-maps you ...

How come I cannot even ping my server from my private net to the dmz.
Both machines have statix nat addresses.
So from eth1, 10.10.10.2 I ping the dns name of the public ip address of the
server on the DMZ,

Hi - please excuse this newbie question, but how do you reset the
priviledged password on a 2900XL switch.  Thanks for your help.
Coop

Hello Cisco-Gurus,
we're going to buy a 12000 GSR in order to connect to 3 to 4
BGP-upstreams that are announcing full routes to us.
This is our current "shopping list":

Anyone know where to look for the temperature MIBS for a wide
range of Cisco routers ranging from 26xx, 36xx, 40xx, 65xx, 70xx ?
Thanx in advance
Wm J King

I have a realy strange NAT requirement that I'm trying to resolve and
I was wondering if anyone can help me with it.
Is there a way that I can nat a destination address based on the time
of day?

I've also installed a CCIE VOICE group for Exam Preperation
Http://groups.yahoo.com/group/CCIE-VOICE/
There are 40 plus like minded professionals in the list,
please make use of the group and lets help eachother.

I am managing a small network with 4 W2K sp4 servers. 2 of them are
domain controllers, 1 file server, the other an exchange server. Both
of my domain controllers have dns installed and they are resolving
names to ip addresses. I am not using forwarders. The network is

does anybody know a way to monitor and log the bandwidth utilization of a
catalyst 2950-EI through SNMP ?
If yes, what is the MIB & the object ?
Thanks.

I am doing a simple VTP test in a lab and I am finding that VTP is not
working as I would expect.  I have 3 switches a 3750 and two
3550-48's.  The 3750 switch is configured as the VTP server.  The
3550's are configured as VTP clients.

I am trying to log attempted connections via telnet and console send them to
my syslog server.
My config contains the following:
logging 123.123.123.2

Can anyone help I have configured a 827 router with VPN IPSEC to 3005
I can only ibtiate the tunnel from the 3005 but no icmp/IP traffic
flow over the tunnel.
I have attached the config og the 827 I beileve it is a NAT/No NAT

I have a Cisco 7206 with 5 interfaces. There is a DS3 interface with IP
66.236.9.xxx. The other four interfaces are FE. Three of them are
192.168.x.x block and I have NAT setup for them through the 66.236.9.xxx
IP on the DS3 interface. I have the fourth interface setup to talk to ...

Barry,
Do you check your barmar email address at MIT?  I just sent you an email
and wanted to make sure it wasn't spam filtered.  Thanks!

Is it posible to use PIX (with 6.3 IOS) for VPN as well as NAT???
I mean I want to use the same device for following purpose:
1. VPN box for my vpn external client.
2. Nat box for my internal client.