Just wondering if anyone knows what MIB should be used in order to
monitor MLPPP bundle as opposed to single T1s.
Any pointers will be appreciated.
regards,

X no-archive: yes
Captain <captain99_1999@yahoo.com> wrote in message news:<0tj140dv9u2om747rp675id8shc07ef8tl@4ax.com>...

Hey guys,
I put together a resource site with scenarios and tips and tricks for Cisco
CallManager Express 3.0 installations.  The URL is www.futureunix.net/cme.
Please

sorry if I post this msg here.
I have a question about the router Motorola Vanguard 320.
How I can see the configuration?
With a CISCO ROuter, i used telnet x.x.x.x and the sh conf ?

Hope that someone can assist.
I have 3 hosts (host A, host B and host C). Host A is running some kind of
service at port 2000 and we suspect that the service lock certain files and
do not allow Host B to access. Host C is scheduled to download the same

as above, will appreciate if there is a diagram to show me.
thanks.

One of our T1's is with MCI and for two weeks my Cisco router with internal
CSU/DSU has been sending me syslog messages every couple hours or so saying
my serial interface is going up and down. The down time is usually just a
few seconds, sometimes longer which causes our ISDN ...

I have 5 Cisco 4000 routers for my home lab & need to extend the console
cables as well as use somthing like a KVM switch to toggle between routers.
Even just extending the cable also does'nt work..
Has any one tried it or can anyone help?

I have a question maybe some might shed some light on, as I have yet to
figure out what I would have to change to make this work correctly in both
directions.
OK, let me describe this just to make sure people understand what I am

I have two(2) bonded T1's which have
"per packet load balancing" both up
and down.
It works great,(full 3-Mb in both directions).

I need to implement a new router on our network(s), to replace a
multihomed windows server, I need to route between 6 networks
internaly using mainly static routes. The question is -
can I use the 16 port switch module with a 3720 to do this? Cisco do

What is the relationship between aaa authentication and the password
statement under vty lines?  This is a general IOS question, but the
specific box is a 3750 SMI with 12.1.
If I have a configuration with

Can someone help me to remove the following statement from the 4003 switch
config?
   set port channel 2/22-23
I just can't find commands to clear or remove it.

I am currently trying to get three computers hooked up to my Cisco
SOHO router for DSL and Cable connections (formerly known as the 800
series) to share one DSL connection.
When I first set up this network, I had the Ethernet1 interface set to

How one configure 2 ports of etherchannel for alternate path if one or the
other fail? Thanks