Using XP Pro SP1 and installed a 250gb hd. Will not recognize over
137gb. How can I make this work? Does the on board bios to support
48-bit LBA for drives larger than 137GB?
Thanks for any advise.  Phil

Just purchased new kt400 Dragon PE and flashed bios to newest revison.
Started with 256 pc2100 memory.  After OS installation of WinXP. The
memory was upgraded to 2 x 256 corsair pc2700c2 memory modules.  Every
once in a while in Windows, i get the blue screen "page on non_page

info needed

I have a Soyo SY-KT400 Dragon Ultra Platinum Edition motherboard.  I
am trying to install a harddrive onto my computer using the IDE3 slot.
Since I already have 2 hard drives, a CD-ROM, and DVD drive on the
computer, I am trying to put in on IDE3.  The problem is that it never

when i run a CD i either get this error: D:\ Only part of a
ReadProcessMemory or WriteProcessMemory requaest was completed.
or
"The application failed to initialize properly (oxc0000006). Click OK

Hello, I am having some trouble loading windows on the following
system:
SOYO KT600 DRAGON+
AMD XP 2600+(333Mhz)

We have a SY-P4I 845PE Lite and need to know from someone who has a
reliable system going, what brand of memory will work best with this
board?
Thanks!

Does the SY-KT333 Dragon Ultra-Platinum Edition support 333 FSB AMD Athlon
XP?

I have soyo maindoard SY-5ehm, and i have proplem with maxtor ata/133
40gt hard drive. My bios doesn't regocnize that harddrive, so what
could i do? I have only 1 HD on my machine, and it should be primary
master.

I'm looking for someone that has set up a raid on a fileserver with
the referenced MB.  I don't want to go on a wild goose chase since
raid would be 'nice' but not critical.  What I want to do is have this
fileserver run mirrored or mirrored and striped and then beable to

No support info on the model on the makers website, possibly due to age !
Can anyone pse advise " beep codes " applicable to above ?
TIA    Jim
(replies via NG only, pse )

I have K7VEMPRO with WinXP. I see AC97 in hardware, nothing is x'd out. No
sound, just the system speaker will beep when you change the sound volume.
Any ideas? Sound is enabled in bios, etc.
BO

No, as everyone on the Soyo boards told me, there wasn't anything wrong with
the power supply or even the switch.
As soon as I plugged the wires from the switch into the proper position, the
whole things started to power up.  (except that there is no TURBO

I recently purchased and installed the Soyo SY-P4I 845PE motherboard.
Included in the quick start guide was a "Last minute note:" paper. On
this paper, it says the following at the bottom:
"Due chipset limitation, DIMM 1 and DIMM 2 can only be used if 800MHz

The cd that came with the box is messed and I am looking for the
driver for this.  I got the little windows question mark,heh.  Anyone
have it or know a place to get it?