My LI 7000 has the 7IWL-T mainboard. One morning it  stopped the boot
process at "Verifying DMI Pool Data.....". All peripherals are found and
everything seems normal. I just replaced the CMOS battery. Any thoughts at
what's happening and suggestions for fixing?

i have the following problem,
my system does not start up again after installing the soyo 372 raid
driver. i have had flashed the last bios version and without the raid
runs but after rebooting with the new drivers it freezes on the

Anyone experienced this one?
Bandy new KT400 Ultra board.  Powered up initially with minimal hardware,
one HDD, CD drive, floppy drive, one stick 256MB DRAM and video card.
I loaded WinXP Pro/SP1 to a the new HDD.  Set a few personal preferences in

I am sure that many on the forum know about this, but here's my
experience.  On my 2nd to last order from Newegg, after getting my
order set up I clicked on send, and this window appeared;  it said
that I could rate the efficiency and professionalism of Newegg's

Kind of a newbie here with some questions about the Ultra Dragon
P4X400.
I have the system up and running, but having some difficulty tweaking
the bios.  I have seen some posts that talk about clock ratio and

I'm at wits end with my "dream system."  I finished putting it carefully
together.  When I turned it on I got a bunch of beeps.  I reseated the AGP
video card and memory which eliminated that problem.  When I power it up
now, all the fans and drives come on but there is now video ...

This is really strange, on the post screen, everything is squiggly like I am
trying to run 1024x768 on a monitor that only does 800x600, the Windows XP
does it as well, but when I get to the user login screen it all looks fine
and so does Windows.

KT333 Dragon Lite
How does one get the 333 bus?   Is it not 166?    I mean to say dont you set
it in the BIOS at 166?  It does not seem to be available.
Soyo's website claims that this MB supports 2500+ to 3000+.   I need a 166

I plan on setting up two WD1800JB drives in RAID 1 configuration.
I have a Soyo Kt-400 Ultra board and looking for opinions as to using the
on-board RAID controller or investing in a Promise TX2000 controller.
I'm looking for reliability and ease of setup and minimal headaches.

I just built a new system using a kt333 Dragon Ultra Platinum board and an
AMD 2200+.
Every thing went together fine and the system booted up flawless. the only
problem I had is with the Soyo cd that came with the board. when I insert

I know perfectly that I'm talking about a damn old motherboard.
Nevertheless I am desperately searching for a SY-5VA2 BIOS later than
5/15/96. All Soyo Websites offer two 5VA BIOS files but none of them
works. While trying to flash, the Award Flaher Utility (I used versions

What is the phone number for soyo tech support?

I loaded the hardware monitoring utility for the KT400 from the Soyo
installation disk.
When I start the application it tells me there is not Winbond chip
installed.

now i got a bigger PSU with 25A at the 12V Line (Enermax EG365). I'm
unable to soft start the PC after a shutdown by operating system. The
system hangs without any beep and running drives. After switching off
the whole psu the PC will start again. What happens here with the

Unhooked computer to work on another. Card was loose when I unhooked.
When I hooked it back up I had no video. Card installed is a Radeon
G9000 Pro. Tried another card and still no video. Tried original card
in another computer worked fine. Unistalled and reinstalled card