I have just bought this board MS7235 ver 1.1using bios v1.6 and can
overclock my E6300 to a maximum of 320 x 7 and no more.  I could not find
anywhere to increase the cpu vcore voltage in the bios.  I am using the
Corsair Value Select 1Gx2 ddr2 memory modules and Sapphire ATI x-1950 ...

I have a K9N sli platinum board with an Athlon 64 X2 4600+ chip in it
AM2 socket.  i have an eVga 7600 Nvida 256mb card in an pci-e slot and
2GB DDR2 memory.  I'm running and 80GB western Digital and an 250GB
seagate drive both SATA.

I recently installed Vista on a spare hard drive, and the process went
very smoothly - hardly needed to touch anything. However, Vista
doesn't include drivers for my onboard IDE RAID and neither does MSI's
website. Does anyone know if there are plans to release Vista drivers

bonjour a tous
je veux flasher le bios d'un carte mère micro star ms 6333 ver:1
j'ai pas trouver le flash
qu'est ce que je fais

I downloaded the the files for the sata controllers at MSI's support
site( the one for nvidia and the other for Silicon Image 3132), but
being a newbie I'm not sure of the install procedure. The instructions
refer to a floppy and F6 at reboot. Is this for an OS fresh install?

BIG Problem with the new MSI board!!
The 975x Platinum will not boot (the board does not recognize any of my
two RAID controller)
1. PCI  Promise Fasttrack 150 SX4

I have aP4N Diamond mainboard that has 6 ports for sata drives
(cables). Problem is, it only will see a max of 4 (in the bios and/or
XP). According to the MSI website, it states that there is support for
4 sata drives and then support for 2 additional drives with a "Silicon

I am trying to get this new computer going .
it has a RX480 Neo2-F,K8,S939 mobo.
It will display Realtek rtl81105/81695 Gigabite Boot agent press shift
F10 to configure than go as far as to start booting windows than askes

I have a newly assembled K8t-Neo2 Version 1 and the board will not
proceed beyond the "chipset initialization" step when first powered on
(according to the four-LED dianostic display).
Neo2 w/Via K8T800/8237

I'm frequently getting messages which say that the device I have plugged
into my USB port is a high speed device and I should plug it into a high
speed USB port.  I believe that all of the USB ports on my K8N Neo2 Platinum
are USB2 and my

    How can I find out what version of the K8N Neo4 Platinum MS-7125
board I have? My understanding is that there is 3 versions of this
board, 1.0, 2.0, and 3.0. Maybe I am not correct but this is what I
have been told. Any help would be appreciated.