Is USB 2.0 possible using the MS-6547 ver.2 motherboard?  Nothing is said
(that I can fine) in the manual or on their website.

I've got an old S370 MS-6178 Rev 1.1 board that seems to be running an AMI
BIOS version 1.3MR
The BIOS wont recognise 120GB drives, so presumably I need to flash it.
Can anyone confirm that use of the later AWARD BIOS 2.1 provides support to

The LED to the rear panel always shows "CPU incorrectly
mounted/damaged". I've tried another CPU*, and get the same
error/no POST.
I've removed a PCI card, reseated RAM and reset the JBAT CMOS jumper

I've spent over a full day trying this - and I am not new to RAID.
I have allocated 2 x 120GB drives (SATA) to a mirror system which is not
bootable. (My bootable system is on another SATA disk.
The problem is right at the start, as I cannot get to the first screen/s in

I have a new pm8m-v motherboard, fresh install of xp pro.
My computer seems to shut off when it has not been used for more than a
few hours. it does not seem to follow a rule like "x minutes" but I am
not sure.

I'm trying to update a PC with indeterminate components.  The video
card went down and it looks unusual. One borrowed from another PC
wouldn't physically fit. Looking at the card with the fixing bracket
on the left and the edge connector pointing down there are ten fingers

I dont know what happening but I cant get into my BIOS. If I try it will
lockup with _ a cursor flashing and thats it and F8 will not do anything
its like my keyboard locks up ,But when Windows Xp loads its normal>?
I picked up a SATA but it works but I never installed any drivers ...

I have the abiltiy to purchase 2 x 512 of ECC for the above Mobo.  The
manual and other specs fail to mention whether you can or cant use ECC
altogether.  (instead of a 512 bog standard DDR)
http://www.msi.com.tw/program/products/mainboard/mbd/pro_mbd_detail.php?UID=28

Hello, I've tried researching this problem to no avail.  The onboard lan can
not get an ip address except for Windows XP's APIPA 169.254xxx.  Also, the
computer locks up when trying to release and renew the onboard lan adapter's
ip address.

Hi to all
Recently, i bought a MSI Mobo 6330v5 to remplace my dead 6330v3, i bought it
on Ebay, but the saler didn't precise it was on from a Fujitsu PC, so i've
been a little bit surprised..... I' ve flash the bios to have the last one,

I'm about to replace my ATA boot drive with SATA. I have 4 IDE drives and 2
optical drives in this machine. I will probably pull at least 3 of the ATA
drives to use as external backups and I intend to install two 250gb Seagate
SATA drives, one of which, as mentioned earlier, will ...

I have a pentium 4, 3.2 ghz w/ ht on an msi board. I forget which model
exactly, but it has PCI-E and 800 fsb (intel p865? chipset or
something. At the library, can't really check)
My problem is when I try to turn it on, it will turn on for a second

Guys I've recently purchased corsair pc3200 2-3-3-6 ram which i run at
2-3-3-8. I bought 2 (twin matched) sticks... and after installing is
when i noticed problems. I really begin to notice the problem in games!
Everything crashes, from starcraft to battlefield 2. Often with

In anticipation of a newly ordered 4400+ x2, I flashed the Bios of my MSI
K8N NEO2 Plat (MS 7025) to the latest BIOS version 1.B. Since I don't have a
floppy drive in that machine, I used the MSI live update utility and chose
to allow the MSI windows flash utility.

hi I got an enormous problem configuring this drive on the msi k8n
neo2platinum (bios 1.9)
Simply the bios see the hd maxtor 300 on sata2 channel (I got another maxtor
sata1 on first channel) but when loading windows it freezes.