I want to run a RAID 1 on two additional drives.   I do not want raid on my
Windows XP drive.
It does not appear possible to do this as the F6 key (which loads the driver
from floppy) only is functional during the XP installation.

I want to run a RAID 1 on two additional drives.   I do not want raid on my
Windows XP drive.
It does not appear possible to do this as the F6 key (which loads the driver
from floppy) only is functional during the XP installation.

Hi
I have searched around and did not find any overview.
But I remember that 780G is a very low consuming chipset. Right ?
I use it with a 4850E.

I have a Gigabyte GA-X48T-DQ6 mobo and i wonder why motherboard
manufacturers of a lot of brands have the slots for the memory modules close
together where slots 1&2 and 3&4 are concerned.
I have memory modules which have heat sinks mounted and it is impossible to

I have a GA EP45-DS3P motherboard and now have installed XP Pro SP3.  I now
want to add a RAID 1 pair of  drives just for data storage. Despite reading
the GA manual several times I cannot see how to install the Intel Matrix
Storage raid controller in the following structure:

I have two SATA 500GB disks which previously were working with my failed ECS
K8N
SLI Extreme motherboard.    It had two Raid controllers one was NForce4 and
the other a Sil controller.    I cannot recall which one was being used but

On my old PC running XP I used to boot using a floppy disk when I needed to
use my Norton Ghost software and accessing ghost data files on DVD media.
This was working fine.
However now I have my GA-EX38-DQ6 motherboard the DVD drive is not

E.g. an Athlon LE1620 default Vcore is 1.25v, but @ default
200 mhz x 12 just 1.025v is needed : if 45watt is used @1.25v,
then just ( 1.025 ÷ 1.25 )² = 67.24% or 30.25watt is used.  In
dos ( GUI too if no cpu driver is loaded ), user can underclock to

I want to buy 2 x 2GB of DDR2 (not DDR3) 1333Mhz memory.
Is this DDR2 PC10664?
Who makes this?
regards,

I have 2 500GB hard drives, one with Windows XP, the other with
Windows Vista. Both drives (when plugged in stand alone using
different SATA cables into different SATA ports) exhibit the same
symptoms.

unter WinXP SP2 gelingt es mir nicht,
von der dem Board beigefügten DVD den
Realtech HD Audio-Treiber zu installieren.
Es BLEIBT ein gelbes "!" im Gerätemanager.

I'm looking at fitting a non Intel CPU cooler to my GA-EX38-DQ6 motherboard.
But all the ones I've looked at require the removal of the heatsinks on the
bottom of the motherboard.
Would removing these heatsinks have any impact upon the performance of the

I just build my new PC with the GA-EP35C-DSR MB, and so far, so good :)
The only thing thar bothers me is that I installed 2 * 2Go of DDR2
memory (sold together, under the brand "black dragon (GEIL)").
This is supposed to be PC 8500 memory. This is waht is written on the

I've bought this MB and installed Corsair 4GB DDR3 DHX 1600C9DHX Twin3X
(2x2GB) (TW3X4G1600C9DHX) memory which only shows up as 1066 in the BIOS
when I alter the Memory to 1333 the computer refuses to boot up until I
reset the memory to 1066 I'm using a Intel Quad 9550 processor. ...