do any of the AMD 939pin compatible boards work with ECC DDR400 RAM?.
- as far as I can see they work with ordinary DDR400, but I cannot see a
reference to ECC equivalent.

With an Award bios, where do I go to change the memory timing?  Iadded
another gig via two 512meg DIMMs and I have errors.  Using memtest86
1.65 when I have just the ONE stick in, it is OK - no errors.  With two
of the original sticks in plus the one upgrade - errors.

Anyone know if a PCI USB 2.0 card is made that will allow booting from
USB 2.0 with the GA-7Zx Rev: 1.01 board.
Bios upgrade allows big drives, but no mention of usb 2.0 support.
Is it possible to achieve with this board?

Can anyone help me I have a GA-K8VNXP motherboard with a Via K8T800 chipset
I have 4 sticks of identical memory -Crucial 512Mb 184 pin DIMM DDR 400 CL3
unbuffered.
The problem I am having is that when I put 2 sticks of this memory in dimm 1

GA-8ANXP-D Motherboard -
Using PATA to SATA Converter -
I am trying to find information concerning the PATA hard
drive jumper settings.  I had connected the converter and was able to load

got 1.5 GB of ram in 4 sticks to use in my GA-8IPE1000-G m/b in dual channel
mode. will it work? The sticks are 2x512 and 2x256 all ddr500 so i can o/c
my P4 3GHz cpu. thanks in advance

Mobo:  8KNXP Rev. 1
RAM:  2gb
Boot drive:  WD Raptor (2) in RAID0 on ICH5R (C:)
Storage drive:  Maxtor DM10 300gb on IDE. (D:)

Do the EasyTune 5 options SmartFan and CIA-MIB work with this board?
If so, where in the BOIS can I activate them?
Thanks

I am looking to upgrade my MB and memory, but keep all of my other
components as is if possible.  The reason for doing this is to
increase the amount of memory.  
I use this computer for gaming mostly.

A7S8X-MX IN CASE YOU GET THIS BOARD and an AMD chip...
There is a FSB setting on these boards that causes it to stop booting.
The settings in the manual are wrong and causes prblems. Default
settings are for FSB 100

Hello together,
today a i have measured my northbridge temperature. It is 76 degrees
celsius.
My cpu is only 29 degrees. I have mesearured with a infrared measuring

Slick:
The faster system has a 6Y080LO (master) with the OS and a 6Y080PO as the slave
Aren't the Maxtor LOs were slower HDDs?
Paul

What is the correct method for updating the Chipset driver for use
with the Giga-byte GA-K8NXP-9 AMD motherboard?
I have downloaded two versions of the Chipset driver, one from the
Giga-byte website (ver.6.66) and the other from nVidia (ver.6.70 for

First of all, I do think that this cross posting is justified!
I have just installed 2 x 300GB SATA-II hard drives in a RAID Mirror array.
I've installed windows xp with all the updates and all my software. My
motherboard is k8NXP-SLI. I have connected the 2 drives to the Silicon ...

Can anyone figure this out ?
I have 2 systems that are identical.
GA 7N400 Pro v2 (same BIOS settings & switch settings)
AMD +3200, Barton 440mhz (not overclocked)