I currently have 1 512 MB PC2700 (333) memory module and would like to go
up to 1 GB.
Should I get another matching memory module, or is it worth it to get a set
of matching PC3200 (400) memory modules and try to sell the old PC2700?  

I booted up my 4 month old system this morning and the screen stayed on the
inital BIOS bootup screen. It asked for me to press F9 or the Delete Key. I
pressed F9 and got into the setup screen and I just pressed Save and Exit.
The computer is not seeing my video card because I'm not ...

System:
GA-7N400 PRO2
AMD Athlon XP 3000+ Barton 333MHZ fsb chip
Two Kingston HyperX 512mb 184pin DDR 333 (pc 2700) Unbuffered memory

Looking for a way to adjust the CAS settings of my memory -- DDR-400
PC3200 1024MB chips from PowerMemory (PQI) which POST confirms is DDR
Dual Channel Enabled. From the menu within BIOS I can set the frequency
manual but at percentages. However, I don't know what affect this ...

It's not listed on the website yet, but if you have @BIOS installed,
do the update check and you will see its there. I just did the upgrade
and its been fine so far.
RT

Anyone know of a good monitoring program for this motherboard?  I
REALLY like Motherboard Monitor 5, but it doesnt support this board =(
If you know a way to trick MBM5 into working, or know of an equal or
better program then lets hear it!

hi, i get these or similar STOP errors:
Kernal_data_inpage_error STOP: 0x0000007A
(0x0C03DDB14, 0xC0000090, 0xF76C5224, 0x3ABBa880)
NTFS.sys-address F76C5224 base at F7664000, datestamp 3d6d35c1

I was wondering if anyone knew where I could order a factory
replacement northbridge chipset fan for the GA-8KNXP Ultra
motherboard.  I had to replace it when it failed with the large Zalman
heat sink but it still gets too hot during extended usage.  I would

From when I have installed the version F7 of the bios I have found this
problem:
when I try to turn on the computer pressing the button of start, it sets out
but after 1 according to he extinguishes. If I again press the button of

I am rebuilding my computer to upgrade from a P4 system.  I am
re-using the same hard drive and cd-rw drives that I was previously
using.  All IDE drives functioned properly previous to new MoBo
installation.  Motherboard, memory and processor are new retail items.

did anyone install this new driver. I had trouble to install the last
driver before this one. So I m cautious.
Michael

I’m a computer builder, and I’m just trying to finish an upgrade.
The new configuration is:
MB GIGABYTE GA-8GPNXP
1024 MB TWINMOS DDR 400

as the title says, i cant see a option to change my AGP aperture size, all
my other gigabyte boards have this option but not this one.
i need to change it to see if it helps in stuttering issues playing
battlefield 2.

Thinking of replacing the stock cooler that came with my A64 3200+ and was
wondering if there were any particular issues with the above board. For
example would one of the big Zalman coolers fit with the DPS module
installed and would I need to un-install the motherboard?

I have this very irritating problem with my machine.
First off I have got the latest driver for my motherboard which is the
Gigabyte 8N-SLI-R.
The video card is the GV-3D1 SLI with the latest drivers.