would the above work okay, as i don't know what can be o\c on this m\board
to get the cpu to work
thanks

Another one for the Gigabyte board:
http://www.giga-byte.com/Motherboard/Support/BIOS/BIOS_GA-K8NXP-SLI.htm

For the Sil3114, can anyone locate drivers for the Sil3112A?
http://www.siliconimage.com/support/downloadresults.aspx?pid=28&bios=0&drivers=1
&sataraid=0

I've just built a new PC together:
- Mainboard: GigaByte K8VT800 Pro
- CPU-cooler: Arctic CPU Silencer Ultra 64 TC
- Power supply: Enermax EG365AX-VE(G) FMA

Wrote to the group several weeks ago about a new computer I built rebooting
quite frequently. I have run out of things to check.
GA 7VT600-1394 mobo
AMD 32100+/400

Lots of updates, manuals BIOS etc.
http://www.giga-byte.com/MotherBoard/Products/Products_GA-K8NXP-9.htm
http://www.giga-byte.com/MotherBoard/Products/Products_GA-K8NXP-SLI.htm
http://www.giga-byte.com/MotherBoard/Products/Products_GA-K8NF-9.htm

Can someone give me a link to download the Win XP SATA drivers for the
GA-8KNXP.
XP asks for the drivers on floppy when doing it's install.
They are not on the supplied CD.

I've tried everything and still can't run 8x. 4x is fine and stable.
Has anyone else had this problem?
--
Jim Davis, Nature Photography

I have the k8ns ultra 939 64bit mobo with 3500 64 bit AMD and 2 sticks
of kingson 512 ddr,fx 5900,wd 80 hd
This runs about as fast as my old 2800+ barton core 32 bit on a msi
mobo

I have the error detected by the "New Hardware found wizard" of Win XP
related to the Secondary Channel of IDE.
If I check the device from the Compuer Management/Device manager/IDE
ATA/ATAPI controllers"

AOA;
i am using 40 GB harddisk on 8IDML motherboard but when i connecte
d 120 GB segate harddisk it worked fine but when i connect both 120 GB
and 40 GB only 40 GB was detected !! why ??

I can't get any S.M.A.R.T info off my IDE Maxtors attached to the IT8212
RAID controller.
HD's support SMART. SMART is enabled on mobo. Have ITE driver 1.7.1.92.
Is this lacking ITE driver support or does anyone know a way ?

I was successfully running a single WD 36GB 10k RPM SATA drive as the boot
disk (set to "BASE") on my GA-7N400 Pro2 board (Rev 1) for several months.
Then it started to get flakey recognizing the drive when booting. Would take
a couple of reboots to get past detecting the drive and ...

 Okay, I'm trying to figure out why I can't run Prime95 for more than
60 seconds, and why 3D apps crash to the desktop or hang the system when
I try to run anything greater than 1024x768x16.
 Here's my system:

Is there a Gigabyte motherboard available that supports the AMD 64 and
PCI-E. It's the PCI-E bit that appears a bit thin on the ground.
Cheers, Rob.