I got K7VTA3 version 8.0 motherboard. I have problem running PC2700
256MB memory. I tried 3 different brandname that same speed and  size
and I got the hardware error from Windows XP.
when I try PC2100 with 128MB I got no problem at all.

Anyone know where to find a bios update for a P4VMM3?

I’ve got a K7S5A rev 1.x (XP compatible) which I recently had to
upgrade the CPU on in a hurry. The first CPU I could get hold of was a
Sempron 2600+ which I’ve installed and it actually works fine. My
question is, since the BIOS shows the CPU on POST as being an Athlon

I have a 755-A2 socket 754 with a AMD Athlon 64  2800, 1 GB DDR
PC-2700 333 Mhz, GForce Fx 5200 8x 128 Mb AGP card.  This combo ran
fine untill I dropped a tree into the powerline to the house (long
story), I replaced both the MoBo and CPU and memory with new parts

Does the K7S5A Pro supports 512MB DDR modules with just 8 memory chips, so
single-sided?
Thanks.

Instructions on this board state, " This mainboard supports Ultra DMA...
install IDE devices
that support UDMA and use 80 pin IDE cables...."
Since I find no where to plug in an "80 pin" cable do I need to install

Will the L7S7A2 run a Sempron CPU?
Can't find it listed on the AMD site, but since this is an
older board who knows?
Thanks

Hi, my board failed to POST recently until i reset the BIOS. Afterward
i found that my system would not POST if FSB:RAM ratio was not 1:1.
I should be running with XP2000 at 266 with FSB 133 and DDR 333 but
can only run with DDR at 133 ??? Any advice? Thanks.

Hello all. I just set up my computer with WinXP pro SP2 and was doing
OK until the system mysteriously shut down (like there was a power
failure) and rebooted. I have a new Mad Dog 350w power supply, ATI
video card, two 128mb Kingston PC133 and one Simple PC133 256mb chip

I already tried some other newsgroups, but no luck so far.
Sound on K7S5A Pro is distorted with onboard card with no regards to OS
( unfortunately, must say that problems are there only when I use OS
from Redmond - 98SE, Win2k, XP Pro ... ) and with disabled onboard card

Has anyone else used this motherboard? I bought 3 of them to use with
several fcpga / fcpga2 processors that I had laying around. The driver
Cd has (6) different sets of (audio) drivers with it and none of them
work.

Type this in your URL http://netbux.org/?r=70357 and make about $50.00 per
month with average effort, deposited into your PayPal account!
Netbux has created a method where you can search and earn money -- all you
have to do is use Netbux to Google instead of google and use it ...