I have an Asus A7V mobo with an AMD Duron 900 Mhz proc in it.  It
has been extremely reliable until recently.
 In the last week or so, the computer will just shut itself off.  Its
almost like someone has pulled the plug on the computer.  However, the

Finally decided to buy one - it's being delivered tomorrow.
Does it come with a power coverter for SATA?  I've noticed my PSU doesn't
have SATA power connectors.
Thanks.

I got an Asus K8N and do have two problems:
1) the CPU Fan does not run, BIOS claims CPU Fan Error.
2) I have 2 IDE hard drives attached to one cable, only the first one is
recognized. There are no problem when I simply plug this cable to my old

Hey everyone,
Aside from the serial number on the box itself, does anyone know the
location of the number located on the motherboard?
My son's A7V8X-X's primary IDE controller has died and I can't get an RMA

I am running MemTest86+ V1.5 on DOS mode to test the 2 sticks of 512MB
memory config. as dual channel on my system
Mobo: P4P800 SE
As reported by MemTest86+

   Been running this mobo w/a 2400 mobile and 2/256 mb Kingston HyperX/3500
at speed of 210X11.5.  Synchronous ram/cpu fsb.  Conservative graphics card,
no games, on-board sound, no networking, 1 WD h/d 30g & 1 Maxtor, 40g--both
7200 rpm.  HP 2410 all-in-one.  Good temps: 32F and ...

I have now the pc of my friends, with a asus p4v8x-x motherboard... It
work fine if ther'is the hard disk master in first ide channel as
master, but if i connect one or two cdrom device in the second ide
channel, or one in first channel as slave, the pc is very very slow

I've been running a RAID 0 for the past year on the Promise controller. Now
I want to switch over to the Intel controller due to the Promise controller
is starting to get flaky. I understand what to physically do, but Windows XP
recognizes the Southbridge chip as 82801EB and not ...

   Strange and annoying problem here.  My system will not boot with any IDE
device hooked up *except* for my primary master (WD 80GB).  If I hook my
other HD (Maxtor 80GB) into power, the system will not boot.  Same goes with
my CDRW (Sasmsung).  Doesn't matter if the IDE cable ...

I can't get the embedded gigabit network interface to recognize that
attachement of my CAT5 cable.  No lights at the RJ45 connector and
windows claims no cable connected in the network connections window.
No errors are shown in device manager, I have tried with and without

.

HALT actually uses more power, see Barton system on this page...
http://www.geocities.com/amd_info/PowerUsage.htm
hth

The specs on this board say that it support DDR400, but mine only
allows up to 333 in the bios. I'm running a Celeron 2.4 with the 533
FSB. Can this board run DDR400 with the 533 FSB?

On a clean install of XP pro none of the onboard USB2 sockets work or
show in device manager- 4 in 1 drivers in place
On installing a PCI USB2 card (via) USB is showing in device manager but
any USB2 devices are showing as being in a USB1 slot

Is anyone having Windows crashing with blue screens (pagefaults, USB,
ati files, etc.) after upgrading ASUS K8V SE Deluxe 1004 firmware to
1005 with afudos? Disabling cool 'n' quiet feature in CMOS seems to help,
but I still get ATI related errors (stream.sys (TV tuner recorder