a7v333 upgrade to 2GB DDR333 pc2700

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

phantomduck@gmail.com - 29 May 2007 17:37 GMT

Ciao,
I bought 2GB (1GB x 2) DDR 333MHz, PC2700, 2.5V, Non-Parity, Non-ECC,
184-pin for my mobo a7v333, I tried to install them without success.
Somebody can help me?

This is my system configuration:
Motherboard ASUS a7v333
BIOS 1018 beta 4 (I tried with bios 1017)
chipset via kt333
AMD Athlon XP 2000+ (1666Mhz)
Video Card ABIT Siluro GF4 MX

I used jumpfree and no-jumpfree mobo setting. I tried many bios config
but when I power-on the PC, the screen appears black.

Please contact me if you need more information, I need to use these
2gb.
thank you!

Reply to this Message

RobV - 29 May 2007 17:52 GMT

> Ciao,
> I bought 2GB (1GB x 2) DDR 333MHz, PC2700, 2.5V, Non-Parity, Non-ECC,
[quoted text clipped - 14 lines]
> 2gb.
> thank you!

Try with just one stick plugged in. If that works, try the other one by
itself as well. If they work individually, raise the memory voltage in
the BIOS. In the spec, 2.5V is needed. Make sure you have that, or a
bit more (2.6,2.7).

Reply to this Message

Walt - 29 May 2007 18:34 GMT

>Ciao,
>I bought 2GB (1GB x 2) DDR 333MHz, PC2700, 2.5V, Non-Parity, Non-ECC,
[quoted text clipped - 14 lines]
>2gb.
>thank you!

http://www.crucial.com/store/listparts.aspx?model=A7V333

lots of info here for your board
The last time i had this problem it was a bad stick

Reply to this Message